Work with a partner so you don’t damage your gutters when you remove them. If your fascia board doesn’t have any gutters, you may skip this step.
This step is not required, but it makes it easier to remove the board in pieces.
If the fascia board is rotting, try to break off as much of the rotting wood as possible before sawing through the boards.
Don’t pound the nail back into the roof since it may damage the shingles above it.
Wear safety glasses as you work with a circular saw so your eyes are protected.
You can also rent a miter saw if you want to make more precise cuts, but a circular saw will work if it’s all you have. Miter cuts only need to be made if you’re putting your fascia on a corner.
Drip edges are metal flashing pieces along the edge of your roof to help water flow away from your fascia. If you don’t have a drip edge, mark the measurements on the edge of your roof or on the fascia board itself.
Have a partner help you hold the board in place while you nail it so it’s kept straight.
Body filler can be purchased from your local hardware store. Only mix a small amount of the body filler at a time since it dries quickly.
Use any leftover paint you may have from the last time your house was painted.
